Libvirt TRIM/UNMAP

From MalinWiKi
Revision as of 00:31, 6 December 2017 by Roy (talk | contribs) (Some info about UNMAP/TRIM on KVM/Libvirt)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

KVM/Libvirt supports UNMAP, similar to TRIM. That way you can free space used by a VM on a qemu2 vdisk not currently in use.

To do this, you'll need to use UNMAP, similar to TRIM, except that the latter is the ATA counterpart to SCSI's UNMAP. KVM/Libvirt doesn't support the ATA version, so we'll change the driver to SCSI. Usually drives are added as VirtIO. If they are, change this, using virt-manager. Obviously, you can do this on the commandline, but I'm lazy so I just use the GUI. On my box (Debian Jessie), I can't change VirtIO to VirtIO SCSI, so I'll have to remove and re-add the drives. If your version of KVM/Libvirt support changing this, skip steps 2 and 3 and just change it. Otherwise, do as follows

  1. Shut down the VM
  2. Start virt-manager and remove the disk(s) from the VM
  3. Add them in the same order, but as VirtIO SCSI

Now, you need to add a flag to the driver to make it support UNMAP. Changing the XML config file itself may not work too well, so in my experience, I find it easier to just dump the config, change it, undefine (that is, delete, not touching the data) the old VM and recreating one.

virsh dumpxml myvm > myvm.xml

Then change myvm.xml, adding the discard part

<driver name='qemu' type='qcow2' discard='unmap'/>

Undefine and redefine the VM

virsh undefine myvm
virsh define myvm.xml

Start the vm with virsh start mym or with virt-manager and wait for it to start. When done, try du -sh /var/lib/libvirt/images/myvm.qcow2 and run fstrim / inside the VM and check du again. If there are a lot of wasted space, it should be freed by now.

roy